TPO CORNER DRAIN INTAKE

Login to order

Description

TPO CORNER DRAIN INTAKE

DESCRIPTION

The rectangular 90 ° CORNER NOZZLES Art. 45.10, square Art. 39.2P and with round tube Art. 304P – 305P – 307P – 309P – 310P – 311P
– 312P have as their main feature the possibility of being used indifferently for drainage with external or internal downspouts and in particular for those horizontal drains in buildings with perimeter walls of large thickness. They are assimilated to fittings or curves with safe gaskets, for this reason the junction can be placed inside the walls, so the down pipe can be placed at minimum distances from the walls. They must be installed with a slope of 3°.

INSTALLATION TECHNOLOGY

Art. 45.10 and 39.2P IN TPO
1 – Spreading of the TPO membrane; cut it in correspondence with the hole.
2 – Test the nozzle in the hole, at the same time mark the point to be cut with respect to the thickness of the wall, the cut of the pipe
(tang) must be made so that the lower part is longer than mm. 5 of the upper one in case this is used with curves
Art. 46 and 47 (for Art. 45.10) and / or Art. 40 – 41 and 42 (for art. 39.2P), while if the nozzle is placed in the box Art. 118 it must be
cut at 45˚ (see drawing A) and installed with a slope of 3˚.
3 – Weld the flange of the vent on the membrane with hot air (or with glues suitable for plasticized TPO) (see drawing B).
4 – Before engaging the curve, apply an adhesive glue suitable for plasticized TPO. After inserting the curves, make sure that the nozzle tube is inserted into the four tabs that are inside the curves.
5 – Insert the leaf guard and / or gravel guard Art. 44.1 (for Art. 45.10) and / or art. 44 (for Art. 39.2P).
N.B .: Point 1 can be reversed with point 2.
DESCRIPTION OF SPECIFICATIONS – Art. 45.10
Supply and installation of ITALPROFILI® type 90˚ angle vents in stabilized TPO with the following dimensions: shank with a length of mm. 450, height mm. 65, width mm. 100, the flange must be smooth and flexible, equipped with connection bends to the down pipes of Ø 80 or Ø 100 and / or funnel box to the down pipes, complete with leaf guard and / or paraghiaia.
DESCRIPTION OF SPECIFICATIONS – Art. 39.2P
Supply and installation of ITALPROFILI® type 90˚ angle vents in stabilized TPO with the following dimensions: shank with a length of mm. 500, height mm. 100, width mm. 100, the flange must be smooth and flexible, equipped with connecting curves to the downspouts of Ø 80, Ø 100 and Ø 100×100 and / or funnel box to the downspouts, complete with leaf guard and / or paraghiaia

Reviews

There are no reviews yet.

Be the first to review “TPO CORNER DRAIN INTAKE”

Your email address will not be published. Required fields are marked *

Post comment